COM-LINX
Home
Products
  • BROWSE ALL
  • WIRELESS MESH AP
  • WIRELESS MESH AP/POE
  • ETHERNET TO COAX
  • COAX REPEATER
  • COAX TO PoE
  • COM-LINX wAP
  • NETWORK INTERFACE
  • CONNECTORS
  • POWER SUPPLIES
  • CABLES
  • TOOLS
Support
  • On-Site Service
CONTACT US
  • Find a distributor
COM-LINX
Home
Products
  • BROWSE ALL
  • WIRELESS MESH AP
  • WIRELESS MESH AP/POE
  • ETHERNET TO COAX
  • COAX REPEATER
  • COAX TO PoE
  • COM-LINX wAP
  • NETWORK INTERFACE
  • CONNECTORS
  • POWER SUPPLIES
  • CABLES
  • TOOLS
Support
  • On-Site Service
CONTACT US
  • Find a distributor
More
  • Home
  • Products
    • BROWSE ALL
    • WIRELESS MESH AP
    • WIRELESS MESH AP/POE
    • ETHERNET TO COAX
    • COAX REPEATER
    • COAX TO PoE
    • COM-LINX wAP
    • NETWORK INTERFACE
    • CONNECTORS
    • POWER SUPPLIES
    • CABLES
    • TOOLS
  • Support
    • On-Site Service
  • CONTACT US
    • Find a distributor
  • Home
  • Products
    • BROWSE ALL
    • WIRELESS MESH AP
    • WIRELESS MESH AP/POE
    • ETHERNET TO COAX
    • COAX REPEATER
    • COAX TO PoE
    • COM-LINX wAP
    • NETWORK INTERFACE
    • CONNECTORS
    • POWER SUPPLIES
    • CABLES
    • TOOLS
  • Support
    • On-Site Service
  • CONTACT US
    • Find a distributor

COAX REPEATER

Cable Network Extender

If your network is continuously increasing in size, you can add a Com-Linx Repeater and easily extend the range by 250m/800ft.


This will increase your device capacity  by 14 nodes for each time you add a repeater. Com-Linx networks are tested up to 5 repeaters equaling 1375m/4500ft with under 20ms of latency. 


A 1 Gbps IP67 Ethernet connection allows you to connect to WIFI devices, Network switches, IP Cameras, or be used for diagnostic.


The Ethernet port can connect with a 2nd repeater and branch to another part of your mine or business.


Plug-and-Play installation, no need to re-wire Ethernet cables. Simple connections, Waterproof RG-6 type-F for the cable network and and IP67 RJ45 for the Ethernet connections. Power and Ground is supplied via two ring terminals.


Main Features

  • Data rates up to 2 Gbps
  • Maximum PHY rate : 3Gbps
  • Maximum nodes: up to 14 before requiring a repeater
  • Ethernet Ports: 1* IP67, RJ45
  • TX Distance: 250m/800ft
  • TR-069 remote management
  • Flexible frequency selection
  • Interference proof capabilities
  • Advanced data link layer agreement

Specification

RF Specifications:

Max TX Power -  +9dBm

Typical TX Power -  +2dBm

Power TX Mode - Auto/Manual

RX Sensitivity  -  -72dBm

Insertion Loss  -  < 2dB

TX Distance - 250m/800feet

Application Rate - Bidirectional, up to 2.0Gbps


Communication Mode:

Modulation Mode - OFDMA

Sub-carrier Quantity - 512*5

Sub-carrier BW - 195.3125KHz

Modulation - BPSK, QPSK, 8QAM, 16QAM, 32QAM, 64QAM, 128QAM, 256QAM, 512QAM, 1024QAM

MAC Layer Protocol - TDMA/TDD

Maximum PHY Rate - 3Gbps


Latency:

Typical - 3ms

Maximum - 5ms

Delay Jitter - 1ms


Port Property:

Hi/Lo Pass Filter - Built-in

RF Port Mode - F-Female, 75 Ohm

RF Port -  1 Input, 1 Output

Ethernet Port - 1* RJ45 IP67 

Port Spec:  1000BASE-TX *1


Power & Consumption:

Power Input - 57Vdc/200mA

Power - DC 18-75Vdc

Power Consumption - <8W


Power Protection: 

Isolation - 1500 Vdc isolation

Voltage - under & over voltage protection

Current -  over current protection

Power Certification - EN/BS EN 62368-1 certified


Isolation:

Grounding - <5Ω

Anti-Static - Contact-Discharge 6KV, Air-Discharge 8KV


Dimension:

Dimension - 150*100*150mm/6"x4"x6"(L×W×H)


Operating Environment:

Environment - IP68 rated, Waterproof up to 1.5m.

Operating Temperature :  -40~+85 °C

Operating Humidity -  5%~95% , No condensation

Store Temperature :  -40~+85 °C

Copyright © 2025 Com-Linx - All Rights Reserved.

Powered by

  • Home
  • On-Site Service
  • Find a distributor

This website uses cookies.

We use cookies to analyze website traffic and optimize your website experience. By accepting our use of cookies, your data will be aggregated with all other user data.

DeclineAccept